Adjustable Shotgun Choke
 

A Poly-Choke provides you with the most essential feature in successful scatter-gunning...

Pattern Control.

To be 100% effective, 70 to 75% of your pellet load must be evenly distributed within a 30inch circle at any range.

Poly-Choke’s Split-second adjustment gives you the right
pattern for any game, at any range, with any shot load.

 Caution: NEVER SHOOT your gun with the Poly-Choke sleeve unscrewed beyond the two reverse choke settings or with the sleeve removed,

As you will severely damage or ruin the Poly-Choke.

      ***UNLOAD GUN WHEN ADJUSTING CHOKE***

  

Loosening the sleeve one setting at time produces gradually widening patterns.  When you have made one complete revolution of the sleeve and reached the Xtra-full setting again, your Poly-Choke is set for Xtra-full open (Cylinder Bore.)  Two degrees of Reverse Choke, for extremely wide open patterns can be obtained by loosening the sleeve two more settings beyond

Xtra-full open.

            Always test pattern your gun to ascertain which setting will give the most effective patterns.

            Because no two barrels perform alike, your Poly-Choke provides you with three “in-between settings”... Slug, Mod and Full, in order that you may increase or decrease the amount of constriction your particular barrel may need to give you the most effective pattern.  EXAMPLE: If any one of the four major settings produces too tight pattern, adjust the sleeve one setting looser to an “in-between setting.”  If the original pattern was too thin, adjust sleeve one setting tighter.
 

Operating Instructions

 

A Poly-Choke operates like the nozzle of a garden hose... Controlling the shot, exactly as the nozzle controls the water.  It provides nine degrees of choke... Xtra-full Choke to two settings past Cylinder Bore (Spreader Choke).  Note: the Xtra-full setting on the sleeve is used for both Xtra-full Open and Xtra-full choke performance.  Your Poly-Choke is set at Xtra-full choke when you receive it.  Before moving the sleeve, be sure to check the various sleeve settings as shown above.

 

   Always start at the tightest Xtra-full choke setting,

Tightening the sleeve down as far as possible.  When fully tightened the Xtra-full mark will be just past the sight.  Loosen the sleeve slightly, to align sight arrow.  Now the choke is set to deliver its tightest patterns for longer ranges.		  

Poly-Choke Cleaning Instructions

 

    The Poly-Choke must be disassembled and cleaned every time you clean your barrel.  Powder buildup can effect the performance of the choke.  The cleaner the choke the better

            1.  Always unload all guns before cleaning.

           

            2.  Remove the sleeve portion of the choke (this is the adjustable portion of the choke).  Remove by turning the sleeve clockwise, with the gun stock closest to you.

           

            3.  Clean the fingers of the element and the threads of both parts.  Use a cleaning brush and solvent, to remove all powder build up.  Be sure to remove all particles from the slots in the element and wipe down with a clean rag.

 

            4.  Oil the threads on the element and sleeve. To protect and lube the choke, lightly oil the threads with gun oil.  Never grease or use heavy oils on the choke.

 

            5.  Reassemble the choke.  Screw the sleeve counter clockwise on the element until it stops at the setting Xtra-full choke.  It is important to tighten the sleeve completely.  This may take five revolutions. 

Xtra-full is your tightest pattern setting.

 

          6. Turn sleeve clock wise to desired setting. Now you are ready for the field.

 

Good Shooting!!!